Are there variables I can use in the Service URL field?

Modified on 2025-06-10 11:55:56 +0200

We clone a lot of our devices, it would be very helpful if we could put a variable for IP Address in the Service URL field so this would just happen automatically when we clone a device. Is this possible at this time?

Thanks, Mike

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm afraid that's not possible.

Best regards.

Apr, 2011 - Permalink

Can I make a request to have this included in a future release? It would be very helpful.

Thanks! Mike

Apr, 2011 - Permalink

Your request has been "registered" (please understand however, I can't promise or guarantee that this will be implemented in a near future release). Thank you for the feedback.

Apr, 2011 - Permalink

Great! Thanks!

Apr, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Are there variables I can use in the Service URL field?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.