Hello, I have Ericcsson MINI-LINK Traffic Node with full information about interfaces in ifTable, but when I try to get value of ifNumber.0 OID it returns "No such name" error.

As I understand without value in this OID "SNMP traffic" sensor cannot be created. PRTG also returns Error Message:"No Such Name (SNMP error # 2)".

How can I monitor interfaces bandwidth on this device?

thank you.

Article Comments

Hello,

can you please use our SNMP Tester to scan against the device and try a bit with the OIDs and also try adding .1 or .2

Do you always get 'No such name'?

Best Regards


Apr, 2011 - Permalink

SNMP Tester output:

Scanning Standard Interfaces...

4/4/2011 5:39:50 PM Start Scan

4/4/2011 5:39:50 PM SNMP Version: V1

4/4/2011 5:39:50 PM Delay: 0

4/4/2011 5:39:50 PM Force32: No

4/4/2011 5:39:50 PM Single Get: No

4/4/2011 5:39:50 PM GET: 1.3.6.1.2.1.2.1.0

4/4/2011 5:39:50 PM Try 1

4/4/2011 5:39:50 PM Start 3312928

4/4/2011 5:39:50 PM Done 3312928 Status=0

Result: #N2

Found standard interfaces:

No standard interfaces found

I have the same result when adding .1 or .2 - "no such name".

ifTable shows 292 interfaces.


Apr, 2011 - Permalink

This very much sounds like a problem in the configuration. Maybe the used SNMP Community is not allowed to access this iftable or the OIDs.


Apr, 2011 - Permalink