Solutions

Send alarm when remote probe goes down

Modified on 2025-06-10 11:56:22 +0200

We have a probe on a site that sometimes goes down, and it has noting to do with the remoteprobe. There is something on the network thats playing with us. So when the remote probes is disconnected, we need to get an alarm about that. How to do it? Havent found any solution.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you would have to setup a State Trigger on the according "Probe Health"-Sensor. That should then alarm you if this probe gets disconnected.

best regards.

Apr, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Send alarm when remote probe goes down

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.