Solutions

Remote Probe with DynDNS

Modified on 2025-06-10 11:56:39 +0200

I need to set up a remote probe on a network without a fix IP adress. But the core-server only accepts ip adresses for remote probes. When i try to put the dyn-dns-name into allowed IP-adresses i don't get connection to the remote probe. i need to put in an ip adress...

how can i get connection to the remote probe via dyndns?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

are you referring to the "Allow"/"Deny IPs"-Lists under "Setup"->"System Administration"->"Probes" where you want to put in the DynDNS-hostname?

Best regards.

Mar, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Remote Probe with DynDNS

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.