Upgrade PRTG 5 to PRTG 8 on a new server

Modified on 2025-06-10 11:56:56 +0200

Hello,

I need to migrate a PRTG Traffic Grapher V5 to the new PRTG Network Monitor 8 on a new server. Is there any procedure for this migration?

Are Windows 2008 64 bits versions supported for PRTG?

Thank you

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you would have to upgrade to PRTG 6 first, and then you could consider following: How can I upgrade from previous PRTG versions to PRTG V8?

PRTG 8 fully supports Windows 2008 R2 (64bit).

Best Regards.

Mar, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Upgrade PRTG 5 to PRTG 8 on a new server

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.