Solutions

Multiple IPs in Syslog sensor setup?

Modified on 2025-06-10 11:57:26 +0200

Probe/Sensor/Syslog Specific "sender". When specifying the sending IP address can you list multiple IP address separated by comma's (example 10.10.10.1, 10.10.10.2, 10.10.10.3

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm afraid multiple IPs are not possible.

Best Regards.

Mar, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Multiple IPs in Syslog sensor setup?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.