Whenever the bandwith on a GE or POS interface in the Cisco ASR 1000 goes above 70 Mbps,the PRTG graph becomes too jittered.
Hi,I have an issue with prtg for monitoring Cisco asr 1000 interfaces.
Modified on 2025-06-10 11:57:34 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
which exact version of PRTG are you running? With which sensors do you monitor these interfaces and with which scanning interval?
best Regards.
Mar, 2011 - Permalink