Is it possible to save "Cross Reference" to a file?

Modified on 2025-06-10 11:58:25 +0200

I need a report (or list) of all notifications, thresholds and scanning interval configured on my PRTG Network Monitor (v. 8.3.1.2080). I didn´t find a way to do it including all the informations I need. Is there a way?

If there isn´t another (better) way, I found some of these informations on "Cross Reference", but I have about 7k sensors and I need to get all this information on a file (.txt, .xls, whatever). Is it possible?

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Bruno,

I'm afraid there might not really be a solution for this, other then to use the XML-Configuration file itself.

best Regards.

Mar, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Is it possible to save "Cross Reference" to a file?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.