Dual Wan monitoring on a SonicWall TZ200

Modified on 2025-06-10 11:58:26 +0200

I have a SonicWall TZ200 with a dual wan setup (Cable and DSL). How can I setup PRTG to notify me if either WAN connection goes down? Is there a way to have PRTG send a notification if the WAN goes down for more than X minutes?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm afraid you can only add a state trigger with the latency of "x minutes" on both sensors (one for each interface), where the triggers will then notify you when an interface is down.

Best Regards.

Mar, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Dual Wan monitoring on a SonicWall TZ200

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.