Can I add a sensor to many devices at the same time?

Modified on 2025-06-10 11:58:38 +0200

I need to put sensors WMI (Logged User / Last Up date) at 480 devices

Att

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

that might only be possible using Device Templates. Create the device template from an existing device with this sensor, and then edit the template that only this sensor is left in it. Then apply the template to all the devices necessary and run the auto-discovery.

Best Regards.

Mar, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can I add a sensor to many devices at the same time?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.