Wie kann ich den Warnwert beim Sensor WMI Arbeitsspeicher von 20% auf einen anderen Wert z.B. 10 % ä

Modified on 2025-06-10 12:00:01 +0200

Wie kann ich den Warnwert beim Sensor WMI Arbeitsspeicher von 20% auf einen anderen Wert z.B. 10 % ändern

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hallo,

bei existierenden Sensoren können die Warnungs- und Fehlergrenzwerte in den Kanaleinstellungen des jeweiligen Sensors geändert werden: https://www.paessler.com/manuals/prtg8/sensor_channels_settings.htm

MfG

Feb, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Wie kann ich den Warnwert beim Sensor WMI Arbeitsspeicher von 20% auf einen anderen Wert z.B. 10 % ä

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.