How do I reverse the graph? I have to monitor some interfaces in the "inside" and some on the "outsi

Modified on 2025-06-10 12:00:04 +0200

I have to monitor some interfaces in the "inside" and some on the "outside" of the devices.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

maybe you can use the sensor factory to do this: https://www.paessler.com/manuals/prtg8/sensor_factory_sensor.htm

Best Regards.

Feb, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How do I reverse the graph? I have to monitor some interfaces in the "inside" and some on the "outsi

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.