How can I change Down (Partial) in Cluster single-failover mode to appear as Down only when both MAS

Modified on 2025-06-10 12:01:17 +0200

I only want Down alarms to appear if both MASTER and SLAVE (fail-over) NODES are offline/unreachable/down.

Can this be done?

Cheers,

Chris.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Chris,

as for notifications, 'DOWN'-State Triggers should only react for proper Down sensors not partially down sensors. As for the alarms list in the PRTG webinterface, you could basically simply adjust the URL used, to

http://MY_PRTG_SERVER/alarms.htm?filter_status=5

Best Regards.

Feb, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I change Down (Partial) in Cluster single-failover mode to appear as Down only when both MAS

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.