Default autodiscover disk sensors behaviour?

Modified on 2025-06-10 12:01:25 +0200

I'm looking to change the default disk sensor for autodiscover from multi drive to several single drive sensors. I've created some reports through the API and the data I can retrieve is vastly improved on the single sensor.

Does anyone know if this is possible?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm afraid the WMI Disk Space Sensor Single Drive unfortunately can't be used in device templates for the Auto-Discovery.

Best Regards.

Feb, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Default autodiscover disk sensors behaviour?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.