How to make visible in maps, a sensor's "message"?

Modified on 2025-06-10 12:01:33 +0200

I need to have the result message of an EXE Sensor, always visible in my map .. Not only the integer value (I don't care of it..). I need the message string on the right of ":" output (e.g.: the "OK" message). I've to write some xml code?

Thanks a lot Gianluca

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Gianluca,

this should be possible using the PRTG API with a call similar to:

https://MY_PRTG_SERVER/api/getobjectstatus.htm?id=1002&name=message

Best Regards.

Jan, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to make visible in maps, a sensor's "message"?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.