Solutions

Remote Probe

Modified on 2025-06-10 12:02:10 +0200

I have installed Remote Probe on a clients SBS 2003, opened port(s) on my router etc etc. Connects fine but every sensor is in blue and saying "Not licenced".

I am using the free product with 20 sensors as I have your banner on my website.

I am also successfully monitoring my own SBS 2008

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

How many sensors are you using already? You can check under "Setup -> PRTG Status -> System Status".

Jan, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Remote Probe

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.