Can PRTG 8 monitor active/passive HSRP devices?

Modified on 2025-06-10 12:02:28 +0200

Hello,

i have a Question about monitoring HSRP devices. In our local IT we have some Routers and Switches which are working fine in HSRP mode. There is no problem to monitor the devices themselves but can i check which device is active/master and which is passive/slave and create a notification if the master oder slave fails? This would be very helpful.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Cisco might have a HSRP MIB or OIDs that allow you to monitor which device is active and which is passive.

Jan, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can PRTG 8 monitor active/passive HSRP devices?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.