Solutions

Cancel in-progress autodiscovery?

Modified on 2025-06-10 12:02:43 +0200

Is there some way to cancel an in-progress autodiscovery? I accidentally selected autodiscovery at a group level when I meant to do it at the device level - now it's rediscovering the whole subnet again. I just want it to abort but I can't seem to find a way to stop it once it's started!

Thanks, Tim

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you could try to 'Pause' the group and then after a short while (1-2 minutes) to 'Resume' it. This should cancel the Auto-Discovery thread.

Best Regards.

Jan, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Cancel in-progress autodiscovery?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.