Change Exchange Mail Que WMI Warning setting

Modified on 2025-06-10 12:03:40 +0200

When I use the default WMI sensors for Exchange 2003 I get a Sensor called Mail Que. It works fine, but I want to change the warning levels of this sensor. In the Moment the Sensors is in warning state when there are more then 1 mails in the que. I want the warning state when there are 10 mail in the que. Where do I find the number needed for the failure level?

regards ls

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

in the sensor settings go to the channels tab, select the desired channel, enable limits. Then add a state trigger in notifications.

Jan, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Change Exchange Mail Que WMI Warning setting

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.