Hello, I want to configure PRTG in such a manner that it should show me the bandwidth usage. I have Cyberoam 50ia as my gateway.
Please guide me with the steps.
Thanks and Regards,
Prasad Kulkarni
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello,
This depends whether the Cyberoam supports monitoring protocols that PRTG supports. Most common are SNMP, Netflow or WMI. PRTG is also able to monitor various types of servers (Webserver, FTP, DNS, SQL etc), but for actual hardware it would be necessary for the device to support one of the three mentioned "protocols" to be monitored by PRTG. You can test all three ways with one of our freeware networking tools (https://www.paessler.com/tools): SNMP Tester, WMI Tester and the Netflow Tester.
For bandwidth monitoring it is most likely either SNMP or Netflow.
Best Regards.
Dec, 2010 - Permalink
Hello,
This depends whether the Cyberoam supports monitoring protocols that PRTG supports. Most common are SNMP, Netflow or WMI. PRTG is also able to monitor various types of servers (Webserver, FTP, DNS, SQL etc), but for actual hardware it would be necessary for the device to support one of the three mentioned "protocols" to be monitored by PRTG. You can test all three ways with one of our freeware networking tools (https://www.paessler.com/tools): SNMP Tester, WMI Tester and the Netflow Tester. For bandwidth monitoring it is most likely either SNMP or Netflow.
Best Regards.
Dec, 2010 - Permalink