can I add two sensor graphs together to monitor a MLT?

Modified on 2025-06-10 12:04:23 +0200

can I add two sensor graphs together to monitor a Multi Link Trunk using either version 6 or 7?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

in PRTG 6 you can add sensors with the Aggregation-Sensor, and in PRTG 7 with the Sensor Factory.

Best Regards.

Dec, 2010 - Permalink

Thanks very much...Sensor Factory is perfect

Dec, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

can I add two sensor graphs together to monitor a MLT?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.