How can I invert sensor values from 0% to 100%?

Modified on 2025-06-10 12:04:29 +0200

Hi,

is it possible to invert a (custom) wmi counter value from 0% to 100% resp. 2% to 98%, 10% to 90% and so on? So, some formula in the sensor settings like:

100 - value

Regards, Christian

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

it should be possible to do this with the Sensor Factory.

Best Regards.

Dec, 2010 - Permalink

Yes, that fit´s it... Thanks for help.

Regards, Christian

Dec, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I invert sensor values from 0% to 100%?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.