How can I change the down behavior of multiple SNMP traffic sensors?

Modified on 2025-06-10 12:05:05 +0200

I just setup up 800 SNMP traffic sensors. they all defaulted to no alarm when disconnected. Is there a way to bulk update the show alarm when disconnected (recommended) setting?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Sean,

it should be possible with the Multi-Edit and "Sensors by Type" (in the main menu of PRTG). But usually it will only show 500 sensors max., so you might have to repeat the process

Best Regards.

Dec, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I change the down behavior of multiple SNMP traffic sensors?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.