PRTG shows on my fileserver PE013.

The sensor should show free space on disk C:\ of this server (WMI).

Thanks

Article Comments

Hello,

PE013 indicates a problem with the drive(s). Have there been any changes made to the target host (new hard-drive(s), changed hard-drive(s))?

Does a new sensor work?

Best Regards.


Nov, 2010 - Permalink

Hi

A new sensor is indeed working. But there was no change on the Harddisk - it's a virtuall cluster server.

It's fine when this is a one time issue, but is it possible that I can check a log or so to see where the problem was?

Best Regards


Nov, 2010 - Permalink

Hello,

then the cluster is the issue in this case. PRTG uses the 'DeviceID' to monitor the drives, and this one changes if the cluster switches nodes. A work-around would be to use the Single-Disk WMI Sensors. They have an option to not use the DeviceID, and instead use the drive-letter, which shouldn't change in the cluster.

Best Regards.


Nov, 2010 - Permalink