How do I increase accuracy of downtime display i the 2,30,365 days view.

Modified on 2025-06-10 12:06:13 +0200

The table below has only accuracy with rounding to 1. Is there a way to make it more accurate.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you can change the decimal places shown for the Downtime-Channel on the Channels-tab of each sensor. Simply go to this tab, select the Downtime-Channel and configure it to show 2 decimal places (or the number of decimal places you want).

Best Regards.

Nov, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How do I increase accuracy of downtime display i the 2,30,365 days view.

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.