How do I combine sensors from the same device

Modified on 2025-06-10 12:07:10 +0200

I am unable to figure out how to combine two sensors together from the same device. I would like the bandwidth totaled together for two interfaces. I read the factory sensors section and did not grasp anything. I can not even find examples that would give me a clue.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

e.g.

#1: Sum of channels
Channel(8662,0) + Channel(8661,0)

Please have another look at the manual.

https://www.paessler.com/manuals/prtg8/sensor_factory_sensor.htm

Nov, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How do I combine sensors from the same device

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.