How can I edit data file to remove rogue values?

Modified on 2025-06-10 12:08:27 +0200

Router sometimes gives a nonsense result (e.g. 60MBps for a slow ADSL link) and that suppresses the graphs - I'd like to be able to remove/replace the odd readings.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

the removal of such single peak-values is not possible. What you could do however is to use the Spike Filter in the sensors Channel-tab where you have these 'wrong' peaks. Of course it might also be good to investigate the reason of these peaks (overflows in 32bit SNMP-Counters or WMI-Counters, etc.), if they happen quite frequently.

Best Regards.

Oct, 2010 - Permalink

Perfect solution - thanks Torsten

Oct, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can I edit data file to remove rogue values?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.