Sum channel missing on some SNMP Traffic Monitors

Modified on 2025-06-10 12:08:30 +0200

When adding some SNMP traffic monitors for Cisco devices managed by a service provider, the SUM channel appears to be missing. Is there a reason for this? Can I create this from the existing data?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

newly added SNMP Traffic Sensors should show a SUM-Channel. Can you please check in the Sensors 'Channel'-tab if there is a SUM-Channel, and it's just set to be "invisible" (Not displayed in charts and tables)?

Best Regards.

Oct, 2010 - Permalink

Hi,

Managed to work it out. The channels were set to invisible. Changed the settings and it's all ok now.

Thanks

Oct, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Sum channel missing on some SNMP Traffic Monitors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.