I need to be notified when sensors are ata certain saturation port on my nods. How do I set up the PRTG to email me when these sensors hti a certain percentage of total bandwdth usage?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

you could use PRTGs Sensor Factory to calculate the usage in percentages and then use triggers upon this sensor, to alarm upon the percentage usage.

Best Regards.


Oct, 2010 - Permalink

Where do I get the Sensor Factory?


Oct, 2010 - Permalink

It's a sensor type, to be found under "Custom Sensors". Please also see PRTG Manual - Sensor Factory.


Oct, 2010 - Permalink