Can I create a report that shows the available interfaces on firewalls and switches?

Modified on 2025-06-10 12:08:46 +0200

How can I create a report that show the number of available interfaces on my firewalls and switches?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

I'm afraid it is only possible to generate 'reports' in PRTG from sensors existing in your setup. So you would have to have a sensor for each interface of your router/firewall. Then you could create a report upon them.

Best Regards.

Oct, 2010 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can I create a report that shows the available interfaces on firewalls and switches?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.