Is there a way to determine which sensors and channels have been manually adjusted? I was hoping to have a report that would only show which sensors and channels have been manually adjusted and/or which sensors are not inheriting all settings. If possible, is there a way for this report to possibly list the adjusted values? Any help would be appreciated.
Can I create a report that only shows sensors that were adjusted manually?
Modified on 2025-06-10 12:08:49 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm afraid such a report or list is not possible.
Best Regards.
Oct, 2010 - Permalink