Uptime threshold in reports
Modified on 2025-06-10 12:09:23 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Under system setup I can change the uptime threshold "This value controls the colors shown next to sensor icons in reports." This is a global setting which applies to all generated reports.
Is there a possibility to individually set this threshold for every report?
Article Comments
Hello,
I'm afraid individual thresholds for different reports are not possible.
Best Regards.
Aug, 2010 - Permalink
OK, thanks for your reply. Maybe this is something that Paessler can consider to include in an newer software version.
Aug, 2010 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm afraid individual thresholds for different reports are not possible.
Best Regards.
Aug, 2010 - Permalink