I'm wondering if anyone has any experience with Linksys routers and SNMP.

I'm having a problem with a few Linksys RVL200 routers. When I ask Network Monitor to do an auto-discovery, it's only picking up Ping, HTTP and DNS sensors, and not the interface sensors.

I also have some RVL200's that are working fine with the exact same SNMP settings configured. Is there a known problem with these devices, or is there something I can configure differently to allow PRTG to pick up the sensors I need.

Maybe I need to reboot the Linksys devices?

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Have you tried the SNMPTester app to scan the device?


Jun, 2010 - Permalink

Yes, I tried it but over the WAN. I will try on a local PC at the site.


Jun, 2010 - Permalink

I scanned the device from a PC on the local LAN. This is the error:

error converting OID (SNMP error # 2007)


Jun, 2010 - Permalink