Cisco SNMP Health Power Supply Sensor not working

Modified on 2025-06-10 12:12:09 +0200

I added a Cisco SNMP System Health sensor configured that shows my System Health Power Supplies as "normal" despite having one power supply that is failing.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Can you please open a support ticket? We will need you to run some SNMP Walks against the device to see the raw data it's reporting back.

Benjamin Day
Paessler Support

Feb, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Cisco SNMP Health Power Supply Sensor not working

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.