Solutions

Probe health down out of the blue

Modified on 2025-06-10 12:12:58 +0200

Trying to figure out why a couple days ago the Probe Health is showing 0%, status down, and have this message:

200 % Delay (Interval Delay WMI) is above the error limit of 100 % Delay in Interval Delay WMI. WMI Sensors of this probe cannot be scanned in their specified intervals. Try longer intervals or distribute load over probes.

I have a pretty simple setup and now all disk and SQL checks are not working. Ping checks are fine. Total of 97 sensors and 43 are failing now. What can I do to get this working again?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

It sounds like your WMI credentials have been changed on the AD side. Can you verify the username and password are still good on those hosts?

Benjamin Day
Paessler Support

Feb, 2019 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Probe health down out of the blue

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.