Hi,

I am trying to monitor the UCS Physical Disk, and I get the following error "Could not find any matching data on this device. (code: PE187)"

I downloader the SNMP Tester on the probe where I want to set the sensor. I set SNMP settings properly and select Walk as request type. I run a walk on with the followed OID 1.3.6.1.2.1.25.2.3.1. and checked the value:

"Error # -2003"

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Thank you for the KB-Post. Do you have other SNMP based sensors working fine on the same device in PRTG?

1.3.6.1.2.1.25.2.3.1 is actually another table and not used for the UCS Sensors at all. Do other UCS Sensors work on this device?

best regards.


Jan, 2019 - Permalink