I have a FortiGate firewall whose MIB includes an SSL Tunnel Table (that lists all active tunnels and includes usernames, uptime, IP address, bytes transferred, etc. for each tunnel. I would like to display a table on a map that shows this information, similar to the sFlow Top Talkers table. Thus far, I've only been able to extract numeric information, but not strings. Is there any way to do this in PRTG?
SNMP Sensor With SSL Session User names
Modified on 2025-06-10 12:19:55 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello there,
We've put together a device template that pulls certain metrics from Fortigate devices, see here for more details. Not all data you mentioned might be covered by this template though.
Alternatively: You can of course grab the FORTINET-FORTIGATE-MIB and start creating sensors as mentioned here, but I would strongly recommend to reduce the content of the MIB with our MIB Importer as mentioned in the guide, because of the high amount of entries in that MIB. You basically select only the data you want to have sensors for, otherwise PRTG will never come to an end when trying to create sensors for everything contained in that MIB.
Kind regards,
Erhard
Jan, 2019 - Permalink