Massive or automatic Remote Probes Approval

Modified on 2025-06-10 12:22:19 +0200

Hello, is it possible to approve a remote probe from the API or using powershell?

We have seen some scripts published that allow to automate the installation process of remote probes, but all require the manual approval of each remote probe, none of them allows to leave the probe functioning, always having to go through the process of manual approval.

thanks for your help

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

Unfortunately this process can't get automated or called via API.

Kind regards,
Birk Guttmann, Tech Support Team

Dec, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Massive or automatic Remote Probes Approval

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.