Hey Guys,
Just a quick question, on the Meraki AP statistics sensor, what is the sensor actually monitoring for? In terms of what will put that sensor in a down state and what are the ways to alter these thresholds.
Thanks
Archie
Meraki AP Statistics Client Count Sensor
Modified on 2025-06-10 12:22:24 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Archie,
Thank you for your post.
I'm afraid PRTG actually doesn't have a built in Meraki Sensor - I guess you've created a custom one.
Depending on what the sensor is reporting, you can set different Limits for each of the sensor's channel. This way you can trigger notifications and also have a visual feedback when needed.
Please also refer to this link for more information about limits.
In case this did not help, please forward us the following screenshots for further analysis to support@paessler.com, refering to the case id "PAE1127978":
- Screenshot of the sensor's "Overview" tab
- Screenshot of the sensor's "Log" tab
- Screenshot of the sensor's "Settings" tab
Thank you in advance!
Kind regards,
Andreas Günther
Tech Support, Paessler AG
support@paessler.com
Dec, 2018 - Permalink