How to disable status "Unsual" on PRTG ?

Modified on 2025-06-10 12:23:34 +0200

Can I close the alert?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello cmmourinho,

Thank you for contacting Paessler Support.

The unusual detection can be configured globally under Setup > Monitoring > Unusual Detection. Also, it can be disabled/enabled on device-, group-, probe- and root-level under Advanced Network Analysis > Unusual Detection.

Please refer to the links below for further details: - https://www.paessler.com/manuals/prtg/sensor_states - https://www.paessler.com/manuals/prtg/monitoring_settings#unusual

Best regards,
Sven Roggenhofer [Paessler Technical Support]

Nov, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to disable status "Unsual" on PRTG ?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.