Solutions

Upper Error Limit not working

Modified on 2025-06-10 12:24:41 +0200

I add a Upper Error Limit 1 kbit/s on channel but it seems like not work.

The traffic exceed 1 kbit/s but sensor status still shown ok.

Please refer screenshot:

https://imgur.com/mUIxHsU
https://imgur.com/rybcRoC

Thanks and Regards.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

When you refresh the page manually, does it show the correct status then?

Kind regards,

Erhard

Nov, 2018 - Permalink

Hi Erhard ,

No , there's not show correct status after refresh and wait above 10 minutes.

Thanks and Regards, Ben.

Nov, 2018 - Permalink

Hi ,

After change a browser then everything is ok.

Thanks for your assist.

Kind regards,

Ben

Nov, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Upper Error Limit not working

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.