Hello,

Is it posible to set an channel warning/error only after a multiple repeat of the passed threshold?

Kind regards, Bastiaan

Article Comments

Let's say you scan for the error every 5 minutes - you just set the treshhold for the notification to e.g. 3x that much like 15 minutes (aka. 900 seconds)

State Trigger
When sensor state is STATUS (DOWN/UP)  for at least VALUE seconds, perform NOTIFICATION
When sensor leaves Down state after a notification was triggered, perform

The Treshhold tricker has a similar setting...

Your state is likely determined by a scan-interval - therefor X amount of time of the interval would be the best way forward, unless you use the API and send data to PRTG - where I tend to say change your code and add a channel or use the business process sensor or sensor factory sensor where you might be able to calculate it out...

Regards

Florian Rossmark

www.it-admins.com


Nov, 2018 - Permalink