Change default scan interval when discovered by autodiscover?

Modified on 2025-06-10 12:25:11 +0200

Hi Paessler,

We have undertaken a large scale change to scan intervals to make load a bit lighter and metrics a bit more readable. However new ADSL devices are autodiscovering sensors at 30sec interval for ping and 1 min for traffic and health sensors. Is there a way to make it so that by default autodiscover sensors set to 5 mins?

Kindest Samuel

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Samuel,

In this case I would recommend a device template of your own and use this template then to run auto-discoveries where needed.

Kind regards,

Erhard

Nov, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Change default scan interval when discovered by autodiscover?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.