I have a range of servers with a sensor that calls a perl script. The result is then shown in PRTG, and that part works (it's a script for showing status of Postfix queues).

I've then created a factory sensor that sums up all these sensor results. For some reason the sensor shows old values, ie. if I've forced a refresh of the underlying sensors, the factory sensor is not reflecting the new values (not even after that is refreshed).

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Please make sure that all sensors involved and the sensor factory sensor have the same scanning interval. Could you check that?

Best regards.


Nov, 2018 - Permalink