Solutions

Easier Perfmon Sensors

Modified on 2025-06-10 12:27:10 +0200

I just converted from WhatsUpGold. When I wanted to setup a Performance Monitor sensor, I could just choose whether it would be WMI or SNMP and choose the system and I would get a listing of perf monitors available on that system (it looked very similar to what you get from perfmon itself).

PRTG's method is tedious. Making copy and paste from perfmon the counter details, then paste it into the Custom Sensor. Very time consuming. Also I can't use more than a single counter per sensor.

I hope you guys can improve this down the road.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

If you would like to submit your ideas for a feature request, please follow the following link.

Feature Request

Benjamin Day
Paessler Support

Oct, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Easier Perfmon Sensors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.