Failover Cluster restarting every 30 minutes

Modified on 2025-06-10 12:28:25 +0200

My failover installation is restarting every 30 minutes with the log message: 2018-10-17 08:41:04.522511 (INFO) [thrId: 5240,Core] Trying to restart PRTG Core Server Reason: Cluster: Restarting Core Server

Is this normal?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Christopher,

Normally, it should not happen. However, we need log files from your PRTG to tell you precisely what is going on. Please open a support ticket so we will continue troubleshooting there. Please refer to this KB article in the ticket.

Thank you

Oct, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Failover Cluster restarting every 30 minutes

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.