Automatically show additional channels on interfaces
Modified on 2025-06-10 12:30:12 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Article Comments
Hi there,
The best way to do this to create one dummy device with Ping Sensor, SNMP Traffic Sensors and all other sensors. Then you configure these sensors as you want and create a device template from this device to use it if future auto-discoveries:
https://www.paessler.com/manuals/prtg/create_device_template
Best regards,
Oct, 2018 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
The best way to do this to create one dummy device with Ping Sensor, SNMP Traffic Sensors and all other sensors. Then you configure these sensors as you want and create a device template from this device to use it if future auto-discoveries:
https://www.paessler.com/manuals/prtg/create_device_template
Best regards,
Oct, 2018 - Permalink