I have inherited a remote probe running on a raspberry pi, how do I manage it or add/modify sensors remotely for it considering its on linux?
Mini Probe on Raspberry Pi
Modified on 2025-06-10 12:30:34 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Nick,
Please take a look at this page for a step by step guide to setup mini probes and new sensors. This should contain all required configuration steps.
Kind regards,
Felix Saure, Tech Support Team
Oct, 2018 - Permalink