Add IP addressing to a network map's connectors

Modified on 2025-06-10 12:32:39 +0200

I'm trying to build a network map and would like to list the IP addressing attached to each device's interface (connector). I could add addresses to the device using the 'html after' field, but this wouldn't indicate which interface it is attached to. Can this be done?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Not automatically, no. HTML After fields for each link interface is the way to go here.

PRTG Scheduler | PRTGapi | Feature Requests | WMI Issues | SNMP Issues

Kind regards,
Stephan Linke, Tech Support Team

Sep, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Add IP addressing to a network map's connectors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.