How to monitor SuperMicro switches with PRTG?

Modified on 2025-06-10 12:33:11 +0200

Sensor does not get response from device. SNMP credentials are wrong or device does not support the required uptime OID (1.3.6.1.2.1.1.3.0) for traffic sensors. This OID is mandatory by the SNMP RFC. Check SNMP access rights or contact device vendor. (code: PE244)

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

Please use our SNMP Tester to verify if you can get an SNMP response at all from the device. Try "Read Device Uptime" or option "Walk" on OID 1.3.6 to see how it responds.

Kind regards,

Erhard

Sep, 2018 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How to monitor SuperMicro switches with PRTG?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.